<< Click to Display Table of Contents >> Navigation: Peer Global File Service Help > PeerSync Management Jobs > Running and Managing a PeerSync Management Job > Managing the PeerSync Profile > Updating a Profile Configuration > Editing and Configuring Jobs |
From the Jobs view in the PeerSync Management Configuration dialog, you can make several configuration changes:
To add a new job, click the Add button on the right of the Jobs view and select one of the job types available from the drop-down list below.
Once a job type has been selected, click Apply and complete the PeerSync Job Configuration wizard to complete the job configuration and add the job to the profile.
To edit an existing job, select the job in the Jobs view, and then click the Edit button on the right. The PeerSync Job Properties dialog will open with all available settings grouped by category in the navigation tree.
To enable or disable a job, click the checkbox to the left of the job name in the Jobs view.
To save these changes, click OK on the bottom right of the PeerSync Management Configuration dialog.
You can copy an existing job by selecting the job from the Jobs view and clicking the Copy button on the right. The PeerSync Job Properties dialog will open, allowing you to make changes to the copied job.
Note: You must make at least one change to the job settings. If the job settings remain identical, it will not be saved after the OK button is clicked.
To remove jobs from the PeerSync Configuration, select one job from the Jobs view, click the Remove button on the right. Repeat this for any additional jobs you wish to remove.