PeerSync Help > Interface Features > Selection Tree > PeerSync > PeerSync Job Settings > Job List Display

The Job List Display is the area within the Profiler listing all the Jobs and visually categorizing them based on various modes for improved Job review.

The Profiler supports Job Control functionality that allows every Job to be stopped, started, or restarted individually. To enter the Job Control mode, right click in the Job List Display and select Connect: Enable Job Control Mode from the Profile Job List pop-up menu.

Job Control Mode
Active	This category lists Jobs which are running successfully without any errors.
Active w/Errors	This category lists Jobs which are running but contain errors typically indicating connectivity issues.
Active w/Warnings	This category lists Jobs which are running but contain errors typically indicating Failing Events.
Inactive	Lists Jobs that were disabled or were newly added and the Profiler does not yet know information about them. As soon as the Profile is saved, newly added Jobs will be added to the Pending state.
Pending	Lists Jobs that were enabled or were newly added to the running Profile but have not yet been started.
Stopped	This category lists Jobs which have been stopped since the Profile has been started.

Job Control Bar The Job Control Bar buttons allows every Job to be stopped, started, or restarted individually.
Start Pending Jobs:x	Start all the Jobs that are in a Pending state where x represents the total number of Jobs that are in a Pending state.
Start Job	Start the selected Job that is in a Sopped state.
Stop/Restart Job	Stop or restart the selected Jobs that are in an Active state.
Save Profile and Refresh	When Job changes are made to the running Profile, a Save Profile and Refresh option can be seen at the bottom right corner of the Job List Display. Saving will refresh the Job List Display to reflect any changes. The Job Control Bar buttons become disabled and grayed out to indicate that Profile changes were made which require saving.

Note: An active Profile must be restarted in order for any configuration changes to take effect.