|
<< Click to Display Table of Contents >> Navigation: PeerSync Help > Interface Features > Selection Tree > PeerSync > PeerSync Job Settings > Blackout Settings > Blackout Settings Overview |
Blackout Period
This screen will enable you to set a Blackout period during the daily synchronization. This is a period in which the synchronization will stop and wait until the blackout period has expired according to the specified settings. This would be a useful feature if you wish to stop all the synchronization activities during a particular time when the Network Bandwidth is busy with other activities (such as during working hours). |
|
Suspend active scans when a Blackout period starts |
Enabling this option will pause all the scheduled scans during the specified Blackout and will resume after the Blackout period ends. |
What happens if PeerSync is performing a scan when it enters the Blackout period?
If the option to "Suspend active scans when a Blackout period starts" is enabled the scan will be suspended and resumed at the point it was left off after the Blackout period ends. If this option is not enabled, the scan will be stopped during the Blackout period and will be restarted from the beginning after the Blackout period ends.
What happens if PeerSync was in the middle of transferring a large file when it entered the Blackout period?
PeerSync will allow the transfer to complete but suspend any new events from being processed until the Blackout period ends. The suspended events or scans will be processed after the Blackout period ends.
What happens if a scan is scheduled to run during the Blackout period?
Regardless if the option to "Suspend active scans when a Blackout period starts" is enabled the scan that is scheduled to run during the Blackout period will run after the Blackout period ends. Multiple suspended scans for a single Job will be compiled into a single scan that will run at the end of the Blackout period.