NetApp FPolicy

NetApp Settings

Host Server Name

Edit the host name or IP address of the NetApp filer.

Root Path Prefix

Edit the local path of the NetApp share you wish to monitor.

FPolicy Name

Edit the FPolicy name that is used to register for event notification on the filer. By default PeerSync uses PEERSYNC_COMPUTERNAME, where COMPUTERNAME is the name of the host where PeerSync is running. PeerSync will create the FPolicy name at the start of the Job.

FPolicy Options - Global

Use cDOT Detection

Check this option when using NetApp FPolicy cDOT detection method.

Use Asynchronous Mode

If enabled, PeerSync will not wait for a response from the FPolicy server, which enhances overall performance. To enable Asynchronous Mode via the command line argument use /Q74Y. This option is enabled by default for both NetApp detection methods (7Mode and cDOT) and cannot be disable when using cDOT detection mode.

Disable FPolicy on Close

By default PeerSync will disable the FPolicy name it used to register for event notification when the Job is stopped. Disable this option if you do not want  PeerSync to delete the FPolicy name when the Job is stopped.

NetApp FPolicy Additional Settings - Global

Exclude Volumes

Provides the ability to exclude entire volumes from scans and real-time detection, which enhances overall performance. Enter a list of comma (,) delimited volumes to exclude when using NetApp FPolicy detection during scans or in real-time. Here is an example of excluding volumes vol3 and vol4: vol3,vol4. To exclude volumes via the command line use /Q7-s, where s represents the comma (,) delimited list of volumes to exclude (i.e. /Q7-vol3,vol4).

Include Volumes

Provide a list of comma (,) delimited volumes to include when using NetApp FPolicy detection during scans or in real-time. This field is visible only if the “Exclude Volumes” check box is un-checked.  Here is an example of including volumes vol1 and vol2: vol1,vol2. To include volumes via the command line use /Q7+s, where s represents the comma (,) delimited list of volumes to include (i.e. /Q7+vol1,vol2).

Exclude Extensions

Provide a list of comma (,) delimited file extensions to exclude when using NetApp FPolicy detection during scans or in real-time. To exclude extensions via the command line use /Q70:s, where s represents the comma (,) delimited list of extensions to exclude (i.e. /Q70:tmp,dwl,dwl2). Use %AUTO% for PeerSync to build a list of file extensions dynamically. To use the %AUTO% option via the command line use /Q70. This is the equivalent of using the /QR argument for FPolicy only

Exclude IP addresses

Provide a list of comma (,) delimited IP addresses to exclude when using NetApp FPolicy detection during scans or in real-time.