General

<< Click to Display Table of Contents >>

Navigation:  Peer Global File Service Help > File Synchronization Jobs > Editing a File Synchronization Job >

General


The General page in the Edit File Synchronization Job dialog presents miscellaneous settings pertaining to a File Synchronization job.  You may want to consult with Peer Software's Technical Support team before modifying these values.

To modify these settings:

1.Enter the values recommended by Peer Software Support.

FS-Edit Job-General

Option

Description

Job ID

Unique, system-generated job identifier that cannot be edited.

Job Type

Identifies the job type.  This cannot be modified.

Job Name

Name of this File Synchronization job.  This name must be unique.

Transfer Block Size (KB)

The block size in Kilobytes used to transfer files to hosts.  Larger sizes will yield faster transfers on fast networks but will consume more memory in the Peer Management Broker and Peer Agents.

Verify Block Checksums

If selected, each block sent will be checksummed at both the source and target(s) Agents.

Verify Full File Checksums

If selected, the entire file will be checksummed after it has been sent from the source to target Agents.  If temp files are enabled, the checksum on the target will be calculated prior to renaming the temp file to the base file's name.  If the checksums between source and target(s) do not match, the file will be sent to the retry engine to reattempt the transfer.

Enable Multipart Transfers

If selected, larger files will be broken into smaller chunks and these chunks will be sent over the wire in a parallel fashion. This feature will automatically throttle itself if many other transfers are also waiting to be processed.

Synchronization Priority

Use this to increase or decrease a job's file synchronization priority relative to other configured job priorities.  Jobs are serviced in a round-robin fashion, and this number determines the maximum number of synchronization tasks that will be executed sequentially before yielding to another job.

Timeout (Seconds)

Number of seconds to wait for a response from any host before performing retry logic.

First Scan Mode

Determines which scan type will be used when the job is first started.  For environments where most data is NOT seeded, the FOLDER_BY_FOLDER method will be best.  For environments where most data is seeded, the BULK_CHECKSUM method will result in a faster first scan.

Remove Filtered Files On Folder Delete

If selected, then all child files on target hosts will be deleted when its parent folder is deleted on another source host.  Otherwise, filtered files will be left intact on targets when a parent folder is deleted on another source host.

Require All Hosts At Start

If selected, requires all participating hosts to be online and available at the start of the File Synchronization job in order for the job to successfully start.

Auto Start

If selected, then this file synchronization session will automatically be started when the Peer Management Center Service is started.

2.Click OK to close the Edit wizard or select another configuration item to modify.